Acta Mechanica Slovaca 2010, 14(2):86-91

Analysis of Quality of Relay Control Systems with Correction

Kazimierz Dzierzek1, Franciszek Siemieniako2
1 Bialystok University of Technology, Poland
2 Wroclaw University of Technology

Modeling of relay control systems using Simulink toolbox of the Matlab environment is presented in the paper. The research was performed on systems with static and astatic plants with various parameters, which contained two-position on-off relays without and with correction. Simulation results show positive impact of the correction to the quality of relay control system.

Published: October 31, 2010  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Dzierzek, K., & Siemieniako, F. (2010). Analysis of Quality of Relay Control Systems with Correction. Acta Mechanica Slovaca, 14(2), 86-91
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. Moore H.: MATLAB for engineers. Pearson Education, New York, 2009
    2. Celmerowski A.: Modelowanie i symulacja układów fizycznych Matlab/Simulink. Wydawnictwo Politechniki Białostockiej, Białystok, 2008
    3. Siemieniako F., Gosiewski Z.: Automatyka. T.1, Modelowanie i analiza układów. Wydawnictwo Politechniki Białostockiej, Białystok, 2006
    4. Gosiewski Z., Siemieniako F.: Automatyka. T.2, Synteza układów. Wydawnictwo Politechniki Białostockiej, Białystok, 2007

    This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content