Acta Mechanica Slovaca 2021, 25(3):34-38 | DOI: 10.21496/ams.2021.013

Design and Stress Analysis of Metalhydride Pressure Vessel

Lukáš Tóth1, *, Filip Duda ORCID...1, Natália Jasmínská1, Tomáš Brestovič1
1 Technical University of Košice, Faculty of mechanical engineering, Department of Power Engineering, Vysokoškolská 4, 04200 Košice, Slovakia

The article describes the design and strength calculation of a low-pressure steel tank, which is used for storage of hydrogen in a metal alloy based on Ti and Zr. An external liquid heat exchanger is considered in the design of the metal hydride tank. Strength calculations were performed to verify the selected wall thickness of the vessel and the wall thickness of the selected bottom type according to STN EN 13322-2 standard for the implementation of a metal hydride tank in operating conditions.

Keywords: Hydrogen, metal alloy, metal hydride storage, hydrogen storage, strength calculation.

Received: February 26, 2021; Revised: March 29, 2021; Accepted: March 30, 2021; Published: September 29, 2021  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Tóth, L., Duda, F., Jasmínská, N., & Brestovič, T. (2021). Design and Stress Analysis of Metalhydride Pressure Vessel. Acta Mechanica Slovaca, 25(3), 34-38. doi: 10.21496/ams.2021.013
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. STN EN 13322-2, Prepravné fľaše na plyny. Navrhovanie a výroba znovuplniteľných oceľových fliaš na plyny. Časť 2: Nehrdzavejúce ocele, 2003
    2. Murín, Justín; Hrabovský, Juraj; Kutiš, Vladimír. Metóda Konečných Prvkov Vybrané kapitoly pre mechatronikov, Slovenská technická univerzita v Bratislave, 2014
    3. Bocko, Jozef; Lengvarský, Pavol; Huňady, Róbert; Delyová, Ingrid. Simulácia v programe ANSYS. Stojnícka fakulta, Technická Univerzita v Košiciach, 2020.
    4. COMMUNICATION FROM COMMISION TO THE EUROPEAN PARLIAMENT, THE COUNCIL, THE EUROPEAN PARLIAMENT, THE COUNCIL, THE EUROPEAN ECONOMIC AND SOCIAL COMMITTEE AND THE COMMITTEE OF THE REGIONS. A hydrogen strategy for a climate-neutral Europe, Brussels, 2020.
    5. Lotosky, Mykhailo; Tolj, Ivan; Klochko, Yevgeniy; Wafeeg Davids, Moegamat; Swanepoel, Dana; Linkov, Vladimir. Metal hydride hydrogen storage for fuel cell utility vehicles, HySA Systems Competence Centre, South African Institute for advanced Materials Chemistry, 2019.

    This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content