Acta Mechanica Slovaca 2016, 20(1):52-55 | DOI: 10.21496/ams.2016.008
Operational Properties of Nanocomposites based on Polycaproamide and Modified Montmorillonite
- 1 Lviv Polytechnic National University, Department of Chemical Technology of Plastics, 12, Bandera Str., Lviv, 79013, Ukraine
- 2 Lviv Polytechnic National University, Department of Chemical Technology of Plastics, 12, Bandera Str., Lviv, 79013, Ukraine
A new method of layered silicate (montmorillonite) intercalation by polyvinylpyrrolidone in the solution under ultrasonic treatment is described in this work. The effect of intercalated montmorillonite on physico-mechanical, thermophysical and insulating properties of polycaproamide PA-6 has been determined.
Keywords: nanocomposite; physico-mechanical properties; polycaproamide PA-6; montmorillonite; polyvinylpyrrolidone; thermophysical properties
Published: March 31, 2016 Show citation
References
- Wagener, R., Reisinger, T.J.G. (2003). Rheological method to compare the degree of exfoliation of nanocomposites. Polymer, 44, 7513-7518.
Go to original source...
- ¦lusarczyk, C., Binia¶, W., Fabia, J., Binia¶, D. (2007). DSC and Two-dimensional Correlation Infrared Spectroscopy Studies of PA6/Montmorillonite Composite Fibres. Fibres & Textiles in Eastern Europe, 5-6 (64), 22-26.
- Suberlyak, O.V., Krasins'kyi, V.V., Moravs'kyi, V.S., Gerlach, H., Jachowicz T. (2014). Influence of Aluminosilicate Filler on the Physicomechanical Properties of Polypropylene-Polycaproamide Composites. Materials Science, 50, 2, 296-302.
Go to original source...
- Krasinskyi, V., Suberlyak, O., Klym, Y., Gajdos, I. (2014). Innovative production of nanocomposites on the basis of thermoplastics and montmorillonite modified by polyvinylpirrolidone. XVII International Scientific Conference "Trends and Innovative Approaches in Business Processes", P. 1-6.
- Krasinskyi, V., Suberlyak, O., Klym, Y., Gajdos, I., Jachowicz, T. (2015). Nanocomposites on the basis of termoplastics and montmorillonite modified by polyvinylpyrrolidone. Editor Janusz Sikora, Technological and design aspects of extrusion and injection moulding of thermoplastic polymer composites and nanocomposites. Volume III: Lublin, P. 103-112.
This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.