Acta Mechanica Slovaca 2014, 18(2):64-69 | DOI: 10.21496/ams.2014.021

Preparation and Utilization of Biogas Produced from Wastes in Slovakia

Peter Horbaj*, Peter Lukáč, Marián Lázár, Marta Lengyelová
Technical university of Koąice, Faculty of Mechanical Engineering, Department of Power Engineering, Vysokoąkolská 4, 04200 Koąice, Slovak Republik

In the paper, the authors present actual situation in preparation of bio fuels from biomass in conditions of Slovakia and also some examples of utilization of produced bio fuel. There is short description of bio fuel produced from agricultural waste, from wood and from sewage treatment plant. These 3 ways are most common in our conditions.

Keywords: Biomass, bio fuels, biogas, waste, utilization

Published: October 31, 2014  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Horbaj, P., Lukáč, P., Lázár, M., & Lengyelová, M. (2014). Preparation and Utilization of Biogas Produced from Wastes in Slovakia. Acta Mechanica Slovaca18(2), 64-69. doi: 10.21496/ams.2014.021
Download citation

References

  1. MacKay, D.: Sustainable energy - without the hot air. UIT Cambridge Ltd., 2009, p.368.
  2. Horbaj, P,; Víglaský, J.; Andrejčák, I.: Vyuľitie bioplynu. ES TU Zvolen, 2008. s. 157, ISBN 978-80-228-1857-5.
  3. Rybár, P.; Rybár, R.; Tauą, P.: Alternatívne zdroje energie. TU FBERG Koąice, 2001, s.121.
  4. Vranayová, Z.; Vranay, F.; Očipová, D.: Renewable energy for smart buildings in conditions of the Slovak republic, In: Journal of international scientific publication. Vol. 3, no.1, 2009, p. 486-493. ISSN 1313-2539.
  5. Oravec, M.; ©tevo, S.; Sekaj, I.: Comparison of using simple genetic algorithm and parallel genetic algorithm in heat transfer model optimization. J. Cyber. Inform., 9, 2010, p. 13-18.
  6. Jandačka, J.; Malcho, M.; Mikulík, M.: Biomasa ako zdroj energie. ES TU v ®iline, 2006, s.240.
  7. Koąičanová, D.; Kapalo, P.: A consumer model for researching the integrative effectiveness of renewable energy sources - a design concept of technical equipment. In: Czasopismo Techniczne. Vol. 109, no. 3, 2012, s. 247-253. ISSN 0011-4561
  8. Tkáč, M.; Hvizdoą, S.: Distributed generation and renewable energy sources for sustainable life. In: Distributed Power Generation Systems. Plzeň, 2005, p. 47-52. ISBN 807043371X.
  9. Trebuňa, P.; Kliment, J.; Halčínová, M.; Fiµo, J; Markovič.: Comparison of agglomerative clustering procedures. 978-80-87539-54-5 Plzeň, SmartMotion, 2013, p. 185-189.
  10. Trebuňa, F.; ©imčák, F.; Bocko, J.; Trebuňa, P.: Failure analysis of mechanical elements in steelworks equipment by methods of experimental mechanics. Eng. Fail. Anal., 17 (4), 2010, p. 787-801. Go to original source...
  11. Badida, M.; Lumnitzer, E.; Biµová, E.; Fiµo, M.: The uncertainties of environments parameters measurements as tools of the measurements quality improvement. Univerzitet u Kragujevcu, Kragujevac, 2008, p. 1-5.
  12. Puąkár, M.; Bigoą, P.; Puąkárová, P.: Accurate measurements of output characteristics and detonations of motorbike high-speed racing engine and their optimization at actual atmospheric conditions and combusted mixture composition. Measurement, 45 (5), 2012, p. 1067-1076. Go to original source...
  13. Lázár, M.; Brestovič,T; Schvarzbacherová, E.: Designing low gas flow meters based on the calometric principle of flow rate measuring. In: The Holistic Approach to Environment. Vol. 1, no. 4, 2011, p. 153-162. ISSN 1848-0071.
  14. Marasová, D. et.al.: Analysis model for determination of contact loads between tube-shaped conveyor belt of a pipe conveyor and carrier rolls. In: Cuprum : Czasopismo naukowo-techniczne górnictwa rud. no. 3, 2010, p. 71-76. ISSN 0137-2815.
  15. Martinka, J.; Kačíková, D.; Hroncová, E.; Ladomerský, J.: Experimental determination of the effect of temperature and oxygen concentration on the production of birch wood main fire emmisions. Journal of Thermal Analysis and Calorimetry. Vol. 110, No.1, p. 485-487, 2012. ISSN 1388-6150. Go to original source...

This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.