RT Journal Article
SR Electronic
A1 Mulidrán, Peter
A1 Spišák, Emil
A1 Tomáš, Miroslav
A1 Rohaľ, Vladimír
A1 Stachowicz, Feliks
T1 The Springback Prediction of Deep - Drawing Quality Steel used in V - Bending Process
JF Acta Mechanica Slovaca
YR 2019
VO 23
IS 4
SP 14
OP 18
DO 10.21496/ams.2019.022
UL https://www.actamechanica.sk/artkey/ams-201904-0002.php
AB In the sheet metal forming processes, the material, and in this case deep drawing quality steel DC06 exhibits springback effect, which is governed by strain recovery of material after the load removal. In this contribution, numerical simulation of a bending process was performed and compared with experimental data. The springback is related to many parameters like forming conditions, tool geometry and material properties such as sheet thickness, yield stress, work hardening, strain rate sensitivity and elasticity modulus. In this work, the influence of used material parameters is evaluated. The springback effect of V-shaped sheet metal part made of DC06 steel, with a thickness of 0.85 mm was investigated. Bending angle was set to 90°.  In the numerical simulation, Hill48 and Barlat yield criterions were used in combination with Ludwik's and Swift's hardening models. Achieved data from the numerical simulations were compared and evaluated with experimental test results.