PT  - JOURNAL ARTICLE
AU  - Mulidrán, Peter
AU  - Spišák, Emil
AU  - Tomáš, Miroslav
AU  - Rohaľ, Vladimír
AU  - Stachowicz, Feliks
TI  - The Springback Prediction of Deep - Drawing Quality Steel used in V - Bending Process
DP  - 2019 Dec 20
TA  - Acta Mechanica Slovaca
PG  - 14--18
VI  - 23
IP  - 4
AID - 10.21496/ams.2019.022
IS  - 13352393
AB  - In the sheet metal forming processes, the material, and in this case deep drawing quality steel DC06 exhibits springback effect, which is governed by strain recovery of material after the load removal. In this contribution, numerical simulation of a bending process was performed and compared with experimental data. The springback is related to many parameters like forming conditions, tool geometry and material properties such as sheet thickness, yield stress, work hardening, strain rate sensitivity and elasticity modulus. In this work, the influence of used material parameters is evaluated. The springback effect of V-shaped sheet metal part made of DC06 steel, with a thickness of 0.85 mm was investigated. Bending angle was set to 90°.  In the numerical simulation, Hill48 and Barlat yield criterions were used in combination with Ludwik's and Swift's hardening models. Achieved data from the numerical simulations were compared and evaluated with experimental test results.